Installing Cabinet Savers is easy. Please see the Installation Videos (Harris Gradens and Stone Port) as well as our Drain Cone Installation video on our YouTube channel www.YouTube.com/@Cabinet Savers.
1. Simply place the Cabinet Saver that is the best fit for your cabinet at the bottom of your cabinet.
2. Trim off the front excess so that the cabinet door closes completely.
3. The recommended method of installing the Drain Cone in our video, Drain Cone Installation, is to drill a 1/16″ hole through the Drain Cone into the cabinet base. Then, remove the Cabinet Saver and use the 1/16″ hole as a pilot to drill the larger clearance hole. Another option is to mark the drain hole position on the cabinet and drill a 5/16 or a 3/8” hole through the cabinet where it’s marked. If you choose this option instead of the video option, be sure to cut a minimal amount off the tip of the Drain Cone, as you do not want the drain hole to be too large.
4. In either case, you can add some glue to the outside of the Drain Cone, position it in the drilled hole, and install the Cabinet Saver. Use a minimal amount of glue to allow for easy removal of the Cabinet Saver for cleaning.